SEARCH

服务中心

How to install laser marking machine driver and software (Ezcad)

2020-08-05



(1) Copy the software from the CD Disk / USB Stick and install it, as shown in the figure.

1.jpg

(2) Send EzCad to desktop, as shown in the figure.
2.jpg

(3) You can see the icon of “EzCad” is on the desktop of your computer.
3.jpg(4) Power on the machine, connect the computer with machine via USB cable then Find 
“My Computer”, right-click to choose “Properties” and “Device Manager”, as shown in the figure.

4.jpg

(5) Click “Device Manager”, then right-click to choose “Scan for hardware changes”, you will see “BJJCZ Device / Laser Mark Control 
Board V4 [USB]
”, right-click to choose “Update Driver Software Laser Mark Control Board V4 [USB]”, as shown in the figure.
5.jpg

(6) Choose Browse my computer for driver software, as shown in the figure.

7.jpg

(7) Choose the path of Driver (remember where you put the driver), as shown in the figure.D:\MY20200603\Driver\USB\LMCV4_RL_2030037\Wind7-8-10_64                                  图片112.jpg                     9.jpg

图片112.jpg

(8) After finishing the driver installation, you will see “Laser Mark Control Board V4 [USB]” 
on “Device Manager
”, as shown in the figure.

11.jpg


(9) Okay, you can run the software “EzCad”, as shown in the figure.

13.jpg


推荐产品

Porduct

地址:深圳市 光明区 公明街道 合水口第4工业区 10栋 2楼   手机/微信:135-1984-0918

2021版权所有·深圳市威斯利激光设备有限公司